-Led/UV lamp available
-High quality material
-Environmentally friendly, tasteless
-No shrinkage, no cracking, no yellowing
-Long lasting non-shedding, easy to remove
How to use:
1.trim the nail, clean the nail surface, apply the primer, and illuminate the light (UV1 minute, Led30s)
2.Select the appropriate nail mold, use a double-head pen to take out the appropriate amount of extension glue, apply a proper amount of anti-sticking water, spread the extended glue evenly on the nail mold, and apply the mold to the nail (UV1 minute, Led30s)
3.Remove the nail piece, polish it for the type A, seal the layer, and illuminate the lamp (UV1 minute, Led30s)
1 X Mold
1 X 30ml Anti-stick Water
1 X 13g Extended Glue
1 X Nail Double Pen
1. When choosing a mold, do not choose a mold that is too big or too small. You should choose a nail mold that just covers the real nail. Otherwise, it may appear when the glued mold is attached.
2. Use the phototherapy pen to take the glue. The glue can be evenly coated on the nail mold according to the length to be extended. Do not apply too thin. The two sides of the mold must be coated with the same thickness and the same thickness as the middle part.