Material: Tungsten steel
Type: End mills
Application: Cutting solid wood board, density board, plywood, ecological board.
1. Specially prepared for bench trimming machine, portable engraving machine and so on.
2. No polishing, smooth cutting, no burrs, no burrs, no blackening.
3. Wide range of applications, such as factory building materials, home shops, carpentry enthusiasts.
4. The blade is made of high quality hard alloy and carefully designed, developed and tested repeatedly, which not only improves the service efficiency, but also significantly improves the durability and noise reduction.
5. The hilt is made of hard 45 steel. The spiral design is wear-resistant and not aging.
6. New spray coating, wave resistance to high temperature, corrosion and other features, extended service life.
(1) The cutter can produce smooth surface for the woodworking of hardwood, softwood and synthetic bench, but it should avoid the processing of metal materials such as copper and iron and non-wood materials such as sand and stone.
(2) Make sure to use a properly sized clamping sleeve, as it is worn seriously, not round enough and with taper of inner bore can not provide enough clamping strength, resulting in vibration or twisting off the handle.
(3) Don't assume that the new jacket is safe and reliable.When uneven contact marks or grooves are found in the handle part after clamping, it is indicated that there is slippage and deformation of the inner hole of the clamp. The clamp should be replaced immediately to avoid accidents.
(4) After the tool is installed and clamped, if the tool is found to be pulsating when working, the machine should be stopped immediately, and the clamping is repeated for many times, so that the tool handle and the clamp are fully in contact, and the work is carried out.
(5) The tool shank is in good contact with the clip sleeve. The tool shank must be fully inserted into the clip sleeve and tightened firmly, so that sufficient clamping force can be provided to the tool. A small part of the clip can't be inserted into the clip sleeve, otherwise it will easily cause the knife shank to break and cause damage to the tool.
(6) Use proper safety protection during operation.
1 X Hole saw cutter